Status of the port. Setting wrap(2) disconnects the port from the ring and setting this object to connect(3) connects the port to the ring. If a timed wrap is desired, then writing timedWrap(4) to this object at the same time that a time value is supplied in s3TrPortPartTime is required. Timed wraps will not survive across a reset. In this case the port will go to the wrap(2) state. BeaconWrap(5) indicates that the port is temporary wrapped by the agent due to the station of the port which was beaconing. The wrapped port will be unwrapped by the agent when the station is deinserted from the ring. WrongSpeedWrap(6) indicates that the port is wrapped by the host module. This is due to the wrong speed of a new station which was inserted to the ring. PermBeaconWrap(7) indicates that the port is wrapped by the agent permanently. This is caused by the beaconing station of the port attempting to deinsert/insert to the ring for more than 2 times within 1 minute. The wrapped port will not be unwrapped by the agent. SecurityViolationWrap(8) indicates that the port is wrapped by the agent due to the station not being allowed to insert in the port. The values beaconWrap(5), wrongSpeedWap(6), permanentBeaconwrap(7) and securityViolationWrap(8) can not be written. Note: The securityViolationWrap feature is implemented only in version 4.3 and subsequent agents.