Indicates the status of a failed connection. The value of this object is only valid only between attempts to establish the connection, and may or may not change after successive failed attempts. Options: noFailure (1): Once a system route has been successfully connected, this value is maintained for the duration of the connection. internalError (2): An internal error has occurred. localAllocFailure (3): There is insufficient memory available for ATM DXI to establish this connection. remoteAllocFailure (4): There is insufficient memory available for the destination protocol layer to establish this connection. localNoAccess (5): This route is associated with a SAP that does not exist. remoteNoAccess (6): This route is associated with a SAP that does not exist at the destination layer. remotePvcDown (8): The PVC at the destination protocol layer is down. remotePvcBusy (10): The destination associated with this route is already connected. This typically occurs when the route is a non-MPE (PVC consolidating) circuit. localFcnFailure (11): Flow control negotiation failed. remoteFcnFailure (12): Flow control negotiation failed at the destination protocol layer. localDsnFailure (13): Data size negotiation failed. remoteAliasNotFound (15): The destination alias (atmDxiSRDestAlias) does not exist. remoteNoPvcService (16): The destination protocol layer does not support PVC service. routeStalled (18): An invalid control packet exchange has occurred during the route setup procedure. The route is temporarily stalled but will recover within 5 seconds.