This is the command status for the DS0DP Port Row. The value used in a SET will be replaced by a response value in the GET RESPONSE indicating success or failure. Default Response State used in GET RESPONSE Command ready-for-command (0) initial default status for a row DS0DP Action Commands used in SET Command (1..99) update (1) Can be used optionally when inserting errors in order to get status code back in response clearErrors (14) Resets all error counters and bert test time to zero insertError (16) Inserts the current invalid bit pattern as indicated by the value of ds0dpPortDiagInsErrMode. Response States used in GET RESPONSE Command (100..199) update-successful (101) Action has been successfully performed clear-successful (114) Error counts have been successfully cleared insert-successful (116) Errored bits have been successfully inserted The Error Codes used in GET RESPONSE Command (200..799) err-general-diag-error (200) Unknown request error occurred. err-invalid-loop (202) Unrecognized loop Command requested err-invalid-bert (203) Unrecognized Bert Command requested err-test-in-progress (205) Requested action cannot be performed during bert err-field-cannot-be-set (206) Read-only field was included in SET request err-invalid-command (208) Unrecognized framer Command requested err-snmp-parse-failed (500) Agent could not parse variable err-invalid-snmp-type (501) Variable ASN type does not match Agent defined type err-invalid-snmp-var-size (502) Variable size is too big