This is the command status for the DS1/E1 Link Test Row. The value used in a SET will be replaced by a response value in the GET RESPONSE indicating success or failure. Default Response State used in GET RESPONSE Command ready-for-command (0) initial default status for a row DS1/E1 Action Commands used in SET Command (1..99) update (1) Can be used optionally when modifing insert mode in order to get status code back in response clearErrors (14) Resets all error counters to zero insertError (16) Inserts the current invalid bit pattern as indicated by the value of dsx1StatusInsErrMode. Response States used in GET RESPONSE Command (100..199) update-successful (101) Test action has been successfully performed clear-successful (114) Error counts have been successfully cleared insert-successful (116) Errored bits have been successfully inserted DS1/E1 Status Error Codes used in GET RESPONSE Command (200..799) err-general-status-error (200) Unknown link status table request error occurred. err-link-not-in-service (201) Requested action cannot be performed for OOS links err-link-in-clear-mode (204) Requested action cannot be performed for clear framed or clear unframed configured links err-test-in-progress (205) Requested action cannot be performed during bert err-field-cannot-be-set (206) Read-only field was included in SET request err-link-not-connected (207) Requested action cannot be performed without link connection err-invalid-command (208) Unrecognized Test Command requested err-link-not-in-test (211) Requested action cannot be performed without a bert err-snmp-parse-failed (500) Agent could not parse variable err-invalid-snmp-type (501) Variable ASN type does not match Agent defined type err-invalid-snmp-var-size (502) Variable size is too big