PKTC-EN-SIG-MIB
40 objects
This MIB module enhances the basic management objects defined for PacketCable Signaling protocols by the MIB group pktcSigMib. Acknowledgements: Rodney Osborne - Arris Interactive Eugene Nechamkin - Broadcom Corporation Satish Kumar - Texas Instruments Jean-Francois Mule - CableLabs Copyright 1999-2004 Cable Television Laboratories, Inc. All rights reserved.
Imported Objects
| CLAB-DEF-MIB | pktcEnhancements |
| IF-MIB | ifIndex |
| PKTC-SIG-MIB | pktcNcsEndPntConfigEntry |
| SNMP-FRAMEWORK-MIB | SnmpAdminString |
| SNMPv2-CONF | MODULE-COMPLIANCE OBJECT-GROUP |
| SNMPv2-SMI | MODULE-IDENTITY OBJECT-TYPE Unsigned32 |
| SNMPv2-TC | TruthValue |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.4491.2.2.6.2 | IdentitypktcEnSigMib | This MIB module enhances the basic management objects defined for PacketCable Signaling protocols by the MIB group pktcSigMib. Acknowledgements: Rodney Osborne⦠| ||
| 1.3.6.1.4.1.4491.2.2.6.2.1 | NodepktcEnSigMibObjects | |||
| 1.3.6.1.4.1.4491.2.2.6.2.1.1 | NodepktcEnSigDevConfigObjects | |||
| 1.3.6.1.4.1.4491.2.2.6.2.1.1.1 | ScalarpktcEnNcsMinimumDtmfPlayout | read-write | current | This object defines the minimum playout time for the DTMF digit when IETF RFC 2833 DTMF Relay is used for the egress gateway. If the value set via this pktcEnN⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2 | NodepktcEnNcsEndPntConfigObjects | |||
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.1 | TablepktcEnNcsEndPntConfigTable | not-accessible | current | This table augments pktcNcsEndPntConfigTable. |
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1 | RowpktcEnNcsEndPntConfigEntry | not-accessible | current | An enhancement to pktcNcEndPntConfigTable - where each entry describes endpoint characteristics. |
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.1 | ColumnpktcEnNcsEndPntQuarantineState | read-only | current | This object reflects the state of the Endpoint. When the endpoint is in notification, lockstep or values 'extended lockstep' states, the E-MTA MUST report the ⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.2 | ColumnpktcEnNcsEndPntHookState | read-only | current | This object reflects the 'hook state' and 'NCS Activity' of an endpoint. 'NCS Activity', by definition includes: an active timeout signal, active brief signal ⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.3 | ColumnpktcEnNcsEndPntFaxDetection | read-write | current | This MIB object is used to configure the distinctive fax calling tone (CNG) detection feature on an MTA endpoint with reference to the analog interface[po1]. W⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.4 | ColumnpktcEnNcsEndPntStatusReportCtrl | read-write | deprecated | This MIB object is be used to control the Endpoint Status Reporting, if the feature is supported by the MTA and is configurable. The term 'Endpoint Status Repo⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2 | TablepktcEnEndPntInfoTable | not-accessible | current | This table includes any additional information associated with PacketCable EndPoints. The number of entries in this table represents the number of available Pa⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1 | RowpktcEnEndPntInfoTableEntry | not-accessible | current | An entry in this table MUST be created for each PacketCable EndPoint. The index needs to be the corresponding index in the ifTable for the associated PacketCab⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.1 | ColumnpktcEnEndPntFgnPotSupport | read-only | current | This MIB object indicates the capabilities of the MTA to detect various conditions related to the presence of foreign potential on an endpoint. The MTA MUST se⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.2 | ColumnpktcEnEndPntFgnPotDescr | read-only | current | This MIB object provides information related to the various tests for each detection mechanism supported by the MTA. While the actual contents are vendor-speci⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.3 | ColumnpktcEnEndPntClrFgnPotTsts | read-write | current | This MIB object is used to clear the current test results of supported conditions indicated by 'pktcEnEndPntFgnPotSupport'. Setting a bit to a value of '1' cle⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.4 | ColumnpktcEnEndPntRunFgnPotTsts | read-write | current | This MIB object is used to initiate one or more test cases associated with a supported foreign potential detection. Thus, whenever one or more BITS correspondi⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.5 | ColumnpktcEnEndPntFgnTestValidity | read-only | current | This MIB object is used to indicate the validity of the corresponding test cases that were initiated using the MIB Object 'pktcEnEndPntRunFgnPotTests'. An MTA ⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.6 | ColumnpktcEnEndPntFgnTestResults | read-only | current | This MIB object is used to indicate the results of the corresponding test cases that were initiated using the MIB Object 'pktcEnEndPntRunFgnPotTests'. An MTA M⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.3 | TablepktcEnNcsEndPntLVMgmtTable | not-accessible | current | This MIB table contains the MIB Objects used for managing loop voltage on an MTA. An MTA MUST implement the defined MIB Objects and the associated functionalit⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1 | RowpktcEnNcsEndPntLVMgmtTableEntry | not-accessible | current | Each entry in this MIB table consists of the loop voltage management policy for the specified index. The MTA MUST use the ifIndex with a value of '1' to repres⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1.1 | ColumnpktcEnNcsEndPntLVMgmtPolicy | read-write | current | This MIB Object allows the Service Provider to choose a suitable policy for Loop Voltage behavior on MTAs. Unless overridden by the operator, the MTA MUST use ⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1.2 | ColumnpktcEnNcsEndPntLVMgmtResetTimer | read-write | current | This MIB Object specifies the time duration allowed for an MTA to successfully provision and is only applicable when the MIB Object pktcEnNcsEndPntLVMgmtPolicy⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1.3 | ColumnpktcEnNcsEndPntLVMgmtMaintTimer | read-write | current | This MIB Object allows the operator to specify the time that loop voltage condition will be maintained, irrespective of the changes to the MTA. It is only appl⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.4 | TablepktcEnNcsEndPntLossTable | not-accessible | current | The E-MTA supports two provisioned loss parameters, one for the D/A direction (towards the subscriber) and one for A/D direction (from the subscriber) directio⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.4.1 | RowpktcEnNcsEndPntLossEntry | not-accessible | current | The E-MTA supports two provisioned loss parameters, one for the D/A direction (towards the subscriber) and one for A/D direction (from the subscriber) directio⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.4.1.1 | ColumnpktcEnNcsEndPntLossDA | read-write | current | This object specifies the provisioned loss parameter for the D/A direction (towards the subscriber) in dB. The E-MTA MUST implement this element per the Packet⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.2.4.1.2 | ColumnpktcEnNcsEndPntLossAD | read-write | current | This object specifies the provisioned loss parameter for the A/D direction (from the subscriber)in dB. The E-fMTA MUST implement this element per the PacketCab⦠|
| 1.3.6.1.4.1.4491.2.2.6.2.1.3 | NodepktcEnSigEndPntConfigObjects | |||
| 1.3.6.1.4.1.4491.2.2.6.2.1.4 | NodepktcEnDcsEndPntConfigObjects | |||
| 1.3.6.1.4.1.4491.2.2.6.2.2 | NodepktcEnSigNotificationPrefix | |||
| 1.3.6.1.4.1.4491.2.2.6.2.2.0 | NodepktcEnSigNotification | |||
| 1.3.6.1.4.1.4491.2.2.6.2.3 | NodepktcEnSigConformance | |||
| 1.3.6.1.4.1.4491.2.2.6.2.3.1 | NodepktcEnSigCompliances | |||
| 1.3.6.1.4.1.4491.2.2.6.2.3.1.1 | CompliancepktcEnSigBasicCompliance | current | The compliance statement for devices that implement PacketCable defined Signaling on an MTA. | |
| 1.3.6.1.4.1.4491.2.2.6.2.3.2 | NodepktcEnSigGroups | |||
| 1.3.6.1.4.1.4491.2.2.6.2.3.2.1 | GrouppktcEnSigGroup | current | Enhanced group of objects for the common portion of the PacketCable Signaling MIB. | |
| 1.3.6.1.4.1.4491.2.2.6.2.3.2.2 | GrouppktcEnNcsGroup | current | Enhanced group of objects for the NCS portion of the PacketCable Signaling MIB. This is mandatory for NCS signaling support. | |
| 1.3.6.1.4.1.4491.2.2.6.2.3.2.3 | GrouppktcEnNcsLVMgmtGroup | current | Enhanced group of objects for the loop voltage Management of PacketCable MTAs based on Signaling and configured policies. | |
| 1.3.6.1.4.1.4491.2.2.6.2.3.2.4 | GrouppktcEnNcsDeprecatedGroup | deprecated | This contains a list of deprecated Extension Signaling MIB Objects. |