Also known as K Mem Emulation, this client is used to store any optional or loadable emulations, such as LN03 Plus or QUIC II. Increasing this client's memory allows you to load more than one optional emulation so that it doesn't have to be reloaded every time the print job is sent. If an emulation is loaded to process a print job and there is not enough memory in the emulation client, another emulation already loaded may be unloaded automatically to obtain enough memory. If you notice a delay in printing between jobs that have different nonres- ident emulations, it's possible that the emulations are having to reload each time they're run. Adding to the emulation client may eliminate the unloading and reloading of these emulations and, consequently, increase throughput. It is recommended that you should add at least 1 MB of physical RAM to your printer and increase this memory client by 1 MB for each additional emulation loaded. If your printer has an optional hard disk and the disk swapping option is turned on then you can increase the emulation memory client using this memory. Size is returned in Kilobytes. Note: You should add at least 1 MB to the emulation memory client for each loadable emulation that your printer uses. Failure to add memory to this client may prevent the printer from loading and using the emulation. You should check the documentation accompanying your loadable emulation for information on additional resource requirements. Also increase the emulation client if you're printing complex non-Post- Script jobs that may require more memory to process correctly.